Leaderboard

Razor, you carpooled with Fred Flintstone too?

It does look like flex material. Without seeing the whole side I'm only guessing so... i would drill a hole in the cabinet (under the molding and then fill with silicone) and look inside. Hopefully there are extruded clips/bars holding the face taut so a whole section can come off without dealing with a multitude of clips. From the angle of the photo I'd say this is a signcomp bleed frame. Are there black plastic clips in the gap above/below the face? if so you can remove them with a screwdriver - assuming the whole thing doesn't come off. I'd sure there are videos on tensioning signcomp extrusion kits that can show much better than i could explain. A tensioning tool signcomp will make re-installing the clips easier but again a screwdriver can do the job, just a lot slower. Anyway, that's my guess!

Well said. Thanks for the update, We are only as good as the products we can purchase

Get paid in full for the 1st job. That is a separate PO and completed work with no issues OR....Lien that job As far as the 2nd job, Read in between their Policy lines. It probably says " We can hire any contractor to fix or warranty the work and deduct it from you " This is the usual BS wording and rarely done. They should have called you and told you to fix it and move forward. Maybe it was a simple 15 minute job for you. But the next guy was told " Don't worry about the cost, it is on the other company and charged it without any hesitation to cost. Maybe the Original Company charged you 3 times what the repair company charged. Its all about making money. If you can't get paid, Lien the job. You have NO FRIENDS left at the Original Company,

I never repo signs because of non payment....I remove them because I discovered there is inferior material used by mistake and it is a hazard so I need to remove and repair or asap. I will reinstall asap...oops. While I happen to discuss this with the customer I say " oh by the way...there is a small balance due on this"